Assembly Instructions
Laminate Side Panel
(interior view)
Upper shelf
position holes
Lower shelf
position holes
Figure 1A
Laminate
Metal
Proceed to Step 2
Installation video available
See www.spectrumfurniture.com
15.25”W
[38.7 cm]
7”D
[17.8 cm]
0191814 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Flip-up Shelf for Link Lectern
™
55540
(8) 0100167
8-32 x 1/2” PH
Thread-cutting screw
(8) 051696
8-32 x 1” PHMS
(8) 021588
8-32 Keps Nut
(8) 0285
3/16 Flat Steel
Washer
1. Before You Begin
Figure 1B
For laminate side panels
For metal side panels
(1) 039622
2” Grommet
(1) Flip-up shelf
assembly
26”D
[66 cm]
Determine:
• The side of the lectern the shelf will be installed. (Left or right)
• The shelf position: (Upper or lower)
• Type of side panels your lectern has (metal or laminate)
Figure 1A
Attaching to laminate side panels:
1. Open the lectern door and remove the rack cube
(if equipped).
2. From inside the lectern, use a drill with a 3/16”
drill bit and slowly drill out the corresponding
pre-drilled pilot holes located on the laminate
side panel.
Figure 1B
. Masking tape can be
used on the exterior to minimize chip-out.
Drill with
3/16” drill bit
