Spectracom GSG-5 series, Руководство пользователя с руководством по SCPI

Страница: 90 / 378

Note: The functionality described below only applies to GPS and Glonass . Other
installed satellite systems, such as Galileo, still have their first generation of satel
lites in orbit.
GSG offers three options to configure satellite constellations:
I.
The Default setting refers to the constellation state for April 22, 2015.
II.
Constellation-wide setting of the satellite generation, e.g., by setting all GPS satellites to
Block IIR-M :
Figure 3-20:
Assigning one constellation block to all satellites
To access this configuration view:
1.
Navigate to Select > [ Select Scenario ] > Configure Scenario : View 3/3
2.
Next to the desired Satellite System enter a number of satellites greater than "0",
or Auto (see "Number of Satellites" on page 71), and press Enter to open the first
configuration view, then the RIGHT arrow key to open View 2/2.
Note: The G## numbers refer to the individual GPS satellites (Glonass satel
lites are named R## ).
III.
Explicitly specify the constellation for each individual satellite, using GSG StudioView:
74
CHAPTER
3
•
User Manual GSG-5/6 Series Rev. 26
3.5 "Select" Menu