Spectracom GSG-5 series, Руководство пользователя с руководством по SCPI

Страница: 207 / 378

Scenario File Key
word
Parameter Value Comment
BDSB2 [0, 1] , where 0 cor
responds to 'Off' , and 1
to 'On' Default: 1 ('On')
QZSSL1CA [0, 1] , where 0 cor
responds to 'Off' , and 1
to 'On' Default: 1 ('On')
QZSSL1SAIF [0, 1] , where 0 cor
responds to 'Off' , and 1
to 'On' Default: 1 ('On')
QZSSL2C [0, 1] , where 0 cor
responds to 'Off' , and 1
to 'On' Default: 1 ('On')
QZSSL5 [0, 1] , where 0 cor
responds to 'Off' , and 1
to 'On' Default: 1 ('On')
IRNSSL5 [0, 1] , where 0 cor
responds to 'Off' , and 1
to 'On' Default: 1 ('On')
RandomMpCP [0, 1] , where 0 cor
responds to 'Off' , and 1
to 'On' Enables randomization of initial multipath Carrier
Phase Offset value. Default: 0
MultipathSignals [0, min(8, 16 – NumSig
nals)] The number of multipath channels. Default: 0
[MultipathSignal
INTEGER] INTEGER range: [1, Mul
tipathSignals] 'Header' for the parameters for each multipath signal.
When MultipathSignals is 1 or greater, then a set of
parameters must be specified for each multipath signal.
mpChannel [1, GpsSate
GlonassSate
GalileoSatellites] Specifying which channel that is to be duplicated.Only
GPS or GLONASS channels may be duplicated.
Default: 1
rangeOffset [-999.999, 999.999] Specifying range offset in meters. Default: 0
rangeChange [-99.99, 99.99] Specifying range offset change in meters / rangeIn
terval. Default: 0
rangeInterval [0, 600] Specifying range change interval in seconds with one
decimal accuracy. Default: 0
dopplerOffset [-99.99, 99.99] Specifying Doppler offset in meters/seconds. Default: 0
dopplerChange [-99.99, 99.99] Specifying Doppler offset change in meters/seconds /
dopplerInterval. Default: 0
dopplerInterval [0, 600] Specifying Doppler change interval in seconds.
Default: 0
5.13 Scenario File Format
CHAPTER
5
•
User Manual GSG-5/6 Series Rev. 26
191