Replace a Boot Drive in the Verde 4U Master Node
Replace a Boot Drive
October 2013
Boot Drive Replacement
—
Spectra nTier Verde Array
10
Replace a Boot Drive
Use
the
instructions
in
this
section
to
replace
a
boot
drive
in
the
array.
1.
Using
a
#1
Phillips
screwdriver,
remove
the
four
screws
that
secure
the
cover
of
the
array
to
the
chassis.
Three
screws
are
located
on
the
sides
of
the
array,
while
one
is
located
on
the
top.
2.
Set
the
cover
aside.
Caution
Any damage to the Spectra nTier Verde caused by failure to protect it from
electrostatic discharge (ESD) voids the Spectra nTier Verde warranty. To protect the
Spectra nTier Verde drives from damage:
Wear an anti-static wristband, properly grounded, throughout the procedure. If
a wristband is not available, touch a known grounded surface, such as the
unpainted metal chassis.
Leave the SATA DOM in its anti-static bag until you are ready to install it.
Do not place the un-bagged SATA DOM on any metal surfaces.
Figure 7
Remove the screws on the left-hand
side of the array.
Figure 8
Remove the screws on the
right-hand side and top of the array.
Screws
Screws