Engl
is
h
11
GNSS Toolbox
GNSS Toolbox
is used to control and monitor important
functions in your receiver. These are listed and detailed
below.
•
GNSS Settings
: Constellations and frequencies used in the
receiver.
•
GNSS Status
: Views GNSS reception monitoring screens.
•
Reset
: Resets the receiver.
•
About
: Provides the software version of GNSS Toolbox.
GNSS Settings
•
Open the
GNSS Toolbox
and tap on
GNSS Settings
. This
opens a new window where you can make the following
settings:
–
Tracking mode
: Only the “GPS L1” option is available,
which means the receiver can only operate from the L1
signal of the GPS constellation.
–
Use SBAS
check box: Check this box to enable SBAS
reception, clear it otherwise.
•
Tap
OK
to confirm your choices and return to the GNSS
Toolbox window.
GNSS Status
•
Open the
GNSS Toolbox
and tap on
GNSS Status
.
The default
Position
tab shows the latitude, longitude and
altitude of the current position, as computed by the
receiver, as well the number of satellites used and the
current PDOP value.
