Spectra Precision SP90m, Руководство пользователя

Страница: 38 / 164

26
Receiver User Interface
The diagram below summarizes all the receiver parameters
that you can display or edit from the receiver front panel. It
also shows which keys to use to scroll through the different
screens.
NOTE: You can navigate in the reverse order using the left-arrow button.
Welcome Screen
This screen appears after about 2 seconds of depressing the
Power button. (You may then release this button.)
After about 10 to 20 seconds of displaying the Spectra
Precision logo – corresponding to the receiver boot sequence
– the screen will get blank for a few seconds, then the General
Status screen will appear automatically.
Using the Front
Panel Controls
• : Use the horizontal (left and right) arrow keys to
scroll through the different screens.
Horizontal arrows are also used to switch from a digit to
another when you are editing a numerical value.
Ethernet
Display
Settings
Radio*
GSM**
General
Status
WiFi**
2 sec.
Receiver Mode
Record
Advanced
Settings
Language
Unit
Screen orientation
Screen timeout
Buzzer
ATL Recording
Reset configuration?
Upgrade firmware?
Execute script?
(Startup protection if active)
Anti-theft
Battery charging
ID
GNSS
Position
(Position 2)
(Heading)
ON
OFF
Settings:
- Channel/Freq
- Protocol/Link speed
- Sensitivity
- FEC
- Scrambler
- Transmit power
- Repeater mode
- Repeater number
- Repeater delay
ON
OFF
Settings:
- Power mode
- Pin code
- Antenna selection
ON
OFF
Settings:
- Power mode
- WiFi mode
Client status
AP status
Start Recording:
• Static (Mem)
• Stop & Go (Mem)
• Static (USB)
• Stop & Go (USB)
Stop Recording:
• Yes
• No
Antenna:
- Antenna name
- Antenna height
Ref. Position:
- Position type
- Ref. Position
Base Settings:
- ID
- Output data:
• Port
• Data
Memory Status:
• Delete all G-files?
• Delete all files?
• Format?
(USB key status)
Site Name
Session #1
Session #2
*: Skipped if no
radio installed
**: Skipped if relevant
firmware option
not active
Rover
Base
In
ternal R
adio
• Settings of ext. radio, if any
• Connection to Radio Utility
• Ext. radio settings:
- Port
- Baud rate
- Radio type
ON
OFF
Settings:
- DHCP mode
- Static address
Error
Messages,
if any
Welcome
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK