Attaching the handstrap
Attach the handstrap to the left or the right side of the device, according to your personal preference.
To ensure a good fit:
1.
Thread one end of the handstrap ribbon through
the top handstrap slot; thread from the center
of the device toward the top of the device.
2.
Pull the end of the ribbon back towards the
center of the handstrap and feed it up, over, and
down through the lock buckle on the handstrap
and pull it tight.
3.
Thread the ribbon at the other end of the
handstrap through the bottom handstrap slot;
thread from the center of the device toward the
bottom of the device.
4.
Pull the end of the ribbon back towards the center of the handstrap and feed it up, over, and
down through the lock buckle on the handstrap and pull it as tight as is comfortable for your
hand.
If required, use a small blunt tool to push the ribbons through the handstrap slots on the
device. Do not use a sharp tool.
When using the handstrap, the device should sit firmly in the hand.
Attaching an EMPOWER module (optional)
NOTE –
Before you install or remove a module from the device, make sure the device is powered off or
in Sleep state. For more information, see
NOTE –
You need to re-calibrate the compass after installing or removing the EMPOWER module. For
more information, see
Calibrating the compass, page 65
.
Spectra Geospatial Ranger 5 Data Collector User Guide |
32
Setting up the device