User Manual e-Mobby
Revision: 1.0
Page 13 of 30
Date of release: 2019-02-14
UM0002-EN_e-Mobby 2_1.0.docx
G
Charger cable with strain relief
For charging the batteries. Plug type and connection
value may vary depending on country
H
Kill switch
For cutting off the power and physically separating the
battery connection with the system
J
Thermal fuse
For protecting the drive motors in case of overheating
K
Fuse
For protecting the sound and visual signals located on
top of the pole
3.2 Switching the e-Mobby ON and OFF
To switch on the vehicle, follow the steps below:
1. Make sure the emergency stop is not active (pulled out).
2. In case the charger is connected to mains, unplug the connector and store the connector in the
available space within the enclosure.
3. Make sure the
dead man’s button is positioned onto the dedicated terminal.
4. Push the power button located onto the control panel to initiate the drive system.
5. Once initiated, the indicator lights on top of the control panel are continuously on.
6. The e-Mobby is now ready to drive, a flashing beacon combined with an audible signal indicates
that the device is ready for use.
NOTE:
In case of a Li-ion version, the separate battery indicator may be activated to check the
battery level. A detailed explanation can be found further on in this manual.
WARNING:
The vehicle may only be activated and driven by skilled and authorized operators or
service technician.
Switching off the vehicle can be done in the following ways:
A. Push the power button located at the control panel.
B.
Remove the dead man’s button from the terminal, the drive system switches to a locked condition
and will shut down after x minutes (depending on the set parameters).
C. Push in the emergency button.
D. Kill the power by operating the main switch.
CAUTION:
Option “D” is not recommended for shutting down the vehicle and -in rare cases- may
cause damage to the drive or power system.
NOTE:
The timer for switching off the vehicle is an adjustable parameter and is normally set to
±2 minutes. In case of doubt please consult your service technician or reseller for the
correct value.
3.3 Driving conditions
Besides switching on the e-Mobby, several conditions must be met before the operator can drive:
1. The drive system is fully initiated and active
2.
The dead man’s button is present onto the terminal
3. All lights on the control panel are continuously on
