Atlas™ Series Heated Platens
33
The four zeroes in the lower display (
27
) will quickly be replaced by the
last
set
temperature value (registered in the memory) and the upper
display panel (
28
) will respond accordingly. (i.e. power will be fed to
the heated platens to raise the temperature if the
set
temperature is
higher than the
actual
temperature).
Fig 13. WEST 6100+ Controller Unit on Temperature Controller
Note:
It is good practice when powering down to change the
set
temperature point (
27
) to zero before switching off. Because a
new
set
temperature will have to be input on the controller when
it is next switched on, this will ensure that the heated
platens would not start to heat up unintentionally if a high
(above ambient)
set
temperature had been retained in the
memory.
Changing the Temperature
To alter the set temperature value (
27
) for the heated platens top (
20
)
and lower (
21
) heated surfaces (their temperature will be indicated by
28
32
29
27
31
30
26
Содержание Atlas GS15515
Страница 1: ...Atlas Series Heated Platens User Manual 2I 15515 Issue 21 ...
Страница 3: ...Atlas Series Heated Platens User Manual 2I 15515 Issue 21 ...
Страница 40: ...Notes for Use of Heated Platens ...
Страница 41: ...Notes for Use of Heated Platens ...
