8999071EN: v1.410/10/2019
16
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
5
Adjustment & Setting Up
5.1
Regulation of the height of cut
Height of cut depends on working conditions and volume of the material. The height of cut can be regulated with
the hydraulic system on the tractor or/and with adjusted rear roller of the machine (Figure 18).
The min. height of cut should be between 1 and 3 cm. The machine should always run on the rear roller and not
on the skids.
Figure 18
DANGER!
Working tools never touch the ground. The skids are only the protection against injures.
They do not touch the ground.
5.2
Belt Tension Adjustment
Appropriate belt tension is one of conditions for optimal operating of the machine and for long lasting of the belts
themselves.
Figure 19
WARNING!
Tension the belts only when tractor is disconnected and starting key taken out.
IMPORTANT:
Appropriate belt tension is achieved when at pressing on the belts with the force of 100 N (i.e. 10
kg), we reach a deviation of the belt 1.5 cm!