8999071EN: v1.410/10/2019
10
Original instructions (ENGLISH)
Website: www.spearheadmachinery.com
Start the machine only if all guards of the machine are fit on proper places.
2.2.1.14
It is forbidden to stand in the range of operating of the machine.
2.2.1.15
Do not enter the working zone of the PTO shaft. It is dangerous to approach the rotating parts of the
2.2.1.16
machine.
Keep a safety distance from drive parts outside of the machine (PTO shaft, hydraulic pipes).
2.2.1.17
Before leaving the tractor with the machine attached disconnect the tractor, put the machine steadily
2.2.1.18
on the ground (with the hydraulic lift), apply the hand brake and if the ground is steeply sloping, wedge
the tractor. Take out the starting key.
Do not enter the zone between the tractor and the machine. It is strongly forbidden to be in this zone if
2.2.1.19
the tractor is not properly disconnected, hand brake applied and starting key taken out.
2.2.2
Attachment On The Tractor And Transport
Before attaching the machine on or detaching it of the tractor be sure that hydraulic lift system is in a
2.2.2.1
neutral position.
Check that a category of 3-point linkage on the tractor corresponds to that one on the machine.
2.2.2.2
Be careful! There is a danger of injuries when working near or with 3-point linkage.
2.2.2.3
It is forbidden to be in the zone between the tractor and the machine while working with the hydraulics.
2.2.2.4
Put the 3-point linkage into the position that moving of the machine during transport is not possible.
2.2.2.5
During transport secure the lever of hydraulic lift to avoid any unplanned moving the machine.
2.2.2.6
It is mandatory to install a horizontal blockade during transport and at bigger machines a vertical
2.2.2.7
blockade must be installed, too.
Never leave the tractor cab when the tractor is working.
2.2.2.8
Adjust driving speed to the road conditions.
2.2.2.9
2.2.3
PTO Drive
Use only PTO shafts with all guards, as directed by the producer.
2.2.3.1
All guards on PTO shaft must be in good order.
2.2.3.2
Take care that all guards on the PTO shaft are in proper position during transport or operating.
2.2.3.3
Respect the producer's instructions.
The PTO shaft must be assembled or disassembled only with the engine stopped and the starting key
2.2.3.4
removed.
Take care that PTO shaft is correctly fitted on and correctly secured.
2.2.3.5
The guards of the PTO shaft must be fixed to the machine and to the tractor with chains, to prevent
2.2.3.6
rotation.
Before starting always check that the speed and the rotational direction correspond to those on the
2.2.3.7
machine.
