INSTALLATION INSTRUCTIONS
SBS-2542
Sensor Kitchen Faucet
800-537-2107
www.speakman.com
92-SBS-2542-01
NEED HELP?
For additional assistance or service please contact:
TOOLS & SUPPLIES NEEDED
Pencil
Eye Protection
Phillips
Screwdriver
Drill
Mounting
Hardware
(included)
Measuring
Tape
Adjustable
Wrenches
5 Gallon
Bucket
Drill Bit
Aerator Wrench
(included)
IMPORTANT
MAINTENANCE:
Your new product is designed for years of
trouble-free performance. Keep it looking new
by cleaning it periodically with a soft cloth. Avoid
abrasive cleaners, steel wool, and harsh
chemicals as these will dull the finish and void
your warranty.
See Maintenance section of this document for
additional information.
SAFETY TIPS:
Be sure to read and understand all instructions
before beginning installation.
Inspect all connections after installation.
Cover the drain to avoid loss of parts.
Be sure to wear proper eye protection.
NOTE:
This installation manual covers several
models of Faucets. While the appearance of
your product may differ from those shown, the
installation method is the same.
1
Verify the Rubber Washer is seated in the
base of the Faucet. If not, place the
Rubber Washer over hoses and align to
base of Faucet.
2
Place Hoses and Wiring, one at a time
through the mounting deck. If installing an
optional Deck Plate, position Hoses and
Wiring through the Deck Plate first.
3
From below, slide Easy Mount Nut over
Hoses and Wiring. Position Easy Mount
Nut on to the Faucet Shank
4
A
B
MOUNTING THE FAUCET
Push upward firmly on the Easy Mount Nut
until it makes contact with the underside of
the mounting surface (A). Rotate and hand
tighten into position (B).
A
B
CONNECTION TO WATER SUPPLY
5
Locate the 2 Inlet Hoses that contain Inlet Adapters. Make connections to existing HOT and
COLD Supply Stops. The Inlet Hoses are 9/16”-24 UNF and will accept a 3/8” Compression
Fitting. First loosen connection between Adapter (A) and Hose End (B) so each can rotate.
Wrench tighten Adapters to Supply Stops then wrench tighten Hose Ends to the Adapters . The
Hoses are interchangeable for HOT and COLD connections. Desired connection can be
determined later in the “Temperature Adjustment” section of the manual.
6
1 Minute
FLUSH SYSTEM
Locate the remaining Hose that has a
female end as shown below. Place this
Hose into a bucket. Turn on HOT and
COLD water supplies. Open Faucet
Handle and allow water to run from the
Hose and into the bucket for 1 minute.
7
DRY CONNECTION ONLY!
DO NOT USE ANY THREAD SEALANT ON THIS CONNECTION
CONNECT HOSE TO SOLENOID
Turn OFF water supplies. Assemble the
previously flushed Hose to the Inlet of the
Solenoid. Wrench tighten connection.
