INSTRUCTION, USE AND
MAINTENANCE MANUAL
Page 11 of 45
GB
7.0 MOBILIZATION
THE LIFTING EQUIPMENT MUST WITHSTAND
A MINIMUM RATED LOAD EQUAL TO THE
WEIGHT OF THE MACHINE (SEE PARAGRAPH
TECHNICAL SPECIFICATIONS). DO NOT AL
-
LOW THE LIFTED MACHINE TO SWING.
If the machine has to be moved from its normal work
post, the movement must be conducted following the
instructions listed below (see
Fig. 3
).
• close completely mandrel jaws;
• turn the mandrel until its straight sides are aligned
with machine sides;
• disconnect all machine power supply sources;
• move to limit switch in central position the arm
(
Fig. 3 ref. 2
);
• remove horizontal arm guard by unscrewing the
provided fixing screws;
• sling the machine using belts with a minimum width
of 60 mm;
• pass the first belt behind the horizontal arm as shown
in the figure;
• pass the second belt between the two front openings
of the self-centring table (
Fig. 3 ref. 1
);
• pass the third belt between the two rear openings of
the self-centring table (
Fig. 3 ref. 1
);
• tie up support belt ends above the machine using a
suitable belt ring;
• lift and transport with suitable device with adequate
dimensions.
2
1
Fig. 3
8.0 WORKING ENVIRONMENT CONDI-
TIONS
The machine must be operated under proper condi-
tions as follows:
• temperature: 0° + 55° C
• relative humidity 30 - 95% (dew-free)
• atmospheric pressure: 860 - 1060 hPa (mbar).
The use of the machine in ambient conditions other
than those specified above is only allowed after prior
agreement with and approval of the manufacturer.
8.1
Working position
In
Figure 4
it is possible to identify working positions
A
and
B
.
Position
A
is the main position for wheel fitting and
removal with the mandrel, while position
B
is ideal to
follow wheel bead breaking operations.
Working in these positions allows better precision and
speed during operating phases as well as greater safety
for the operator.
8.2
Installation space
Fig. 4
USE THE MACHINE IN A DRY AND AD-
EQUATELY LIT PLACE, POSSIBLY INDOORS
OR ANYWAY IN A ROOFED AREA, THIS PLACE
MUST BE IN COMPLIANCE WITH APPLICABLE
SAFETY REGULATIONS.
The location of the machine requires a usable space as
indicated in
Figure 4
. The positioning of the machine
must be according to the distances shown. From the
control position the operator is able to observe all the
machine and surrounding area. He must prevent unau-
thorized personnel or objects that could be dangerous
from entering the area.
Space s.r.l.
7300-M009-0_P
GA2645 - GA2645D - GA2645V
