11
13
8
5
6
3
1
1
7L
7R
12
10
x3
x3
x4
2
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
x3
5
8
x5
4
4
x3
x3
9
9
5500V
PROFESSIONAL MANAGER’S CHAIR
ASSEMBLY INSTRUCTIONS
© Office Star Products August 2009
PART
QTY
1.
Base . . . . . . . . . . . . . . . . . . . . . . . 1
2.
Casters . . . . . . . . . . . . . . . . . . . . . 5
3.
Pneumatic Cylinder . . . . . . . . . . . . 1
4.
Seat Plate . . . . . . . . . . . . . . . . . . . 1
5.
Seat Cushion . . . . . . . . . . . . . . . . . 1
6.
Back Assembly . . . . . . . . . . . . . . . 1
7.
Arms (7L & 7R) . . . . . . . . . . . . . . . 2
8.
Arm Screws . . . . . . . . . . . . . . . . . . 6
9.
Flat Washers . . . . . . . . . . . . . . . . . 6
10.
Back Support Screws . . . . . . . . . 3
11.
Seat Plate Screws . . . . . . . . . . . . 4
12.
Back Support (pre-installed) . . . . 1
13.
Allen Wrench . . . . . . . . . . . . . . . . 1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
STEP 2
Align the holes in the Arms (7L & 7R) with the holes in the Seat Cushion (5), attach Arms (7L & 7R) to Seat Cushion (5) using three Arm Screws (8) and
three Flat Washers (9) for each Arm.
FULLY TIGHTEN
ALL
ARM SCREWS (8) USING PHILLIPS SCREWDRIVER (not provided).
STEP 3
Attach Seat Plate (4) to Seat Cushion (5) with the arrow towards the front of the chair, secure using four Seat Plate Screws (11),
FULLY TIGHTEN
ALL
SEAT PLATE SCREWS (11) USING PHILLIPS SCREWDRIVER (not provided).
STEP 4
Attach Back Support (12) to rear of Seat Plate (4) using three Back Support Screws (10).
FULLY TIGHTEN
ALL
BACK SUPPORT SCREWS (10) USING ALLEN WRENCH (13).
STEP 5
Insert Pneumatic Cylinder (3) into Base (1), Place assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
Phillips Screwdriver also needed for assembly
(not provided)
