Space-Ray Ultra 14, Инструкция по установке, обслуживанию и эксплуатации, Страница: 8 / 22

Page 6 of 20
2 UN-PACKING
The appliance is supplied in a carton, broken down into two sub-assemblies, ie Basic Body Assembly and Burner
Assembly.
Where an Orifice Plate is required, it will be found, together with Qty 4- M5x6 set screws (for securing the Burner
Assembly to the Basic Body Assembly) packed with the Burner Assembly.
Any optional equipment supplied is packed inside the carton also.
3 INSTALLATION
Not withstanding their limited scope, the appliance should be installed in accordance with the relevant provisions of
any National Gas Safety (Installation and Use Regulations). Due account should also be taken of any obligations
arising from any National Health and Safety at Work Regulations, National and Local Building Regulations and
National Electrical Wiring Regulations. The appliance must be installed, and where necessary, converted for use on
other gases, by a qualified installer.
3.1 Suspension
3.1.1 The appliance should be located with respect to building construction and other equipment, to permit access to the
appliance for servicing etc.
3.1.2 For suspending the appliance, it is recommended that suitable protected welded chain (ø3mm x 65 links/m) or
ø6mm (minimum) mild steel drop rods and suitable brackets are used. Attach the chains or drop rods to the 4
suspension screws of the appliance, and secure with the hexagon nuts provided,
3.1.3 The appliance must be suspended with its longitudinal axis horizontal, but may have its lateral axis either horizontal
or at an angle of up to 60
0
(maximum) from the horizontal, in either direction, as shown in Fig. 1. below.
3.1.4 The appliance may be mounted off a vertical surface (wall or building support) in which case it is recommended that
use is made of the purpose designed brackets which are available as optional equipment. The angle of the
appliance to the horizontal may be varied up to 60
o
(maximum) by adjusting the length of the suspension chains.
3.1.5 The brackets should first be fixed to the vertical surface by means of M8 (minimum) bolts, (not provided) through
pre-formed holes in the brackets. Attach the appliance to the lower arms of the suspension brackets using 2 of the
suspension screws of the appliance, as shown below, and secure with the hexagon nuts provided.
3.1.6 Attach chains to both the brackets and the 2 remaining suspension screws of the appliance and secure with the
hexagon nuts provided. (see below)