Space-Ray ERP10, Инструкция по установке, обслуживанию и эксплуатации, Страница: 18 / 22

Page 1 6 of 20
7.9 Replacement Parts List
The following is a list of replacement parts that may be required during the life of the appliance.
If it is found necessary to replace parts other than those listed below, Gas Fired Products (UK) Ltd. must first be
consulted. Address details may be found on the front cover of this manual.
Part Part Number
Control Valve (Spark)-Honeywell 4262240
Control Valve (Spark)-S.I.T 4262585
Ignition Control (Honeywell) 4262534
Ignition Control(S.I.T.) 4262535
Burner Assembly - Ignition Unit - (1 x ERP10/20/30/40/45) 4262
Burner Assembly – (1xERP20 – 2xERP30 – 3xERP40/45) 4262
Manifold – ERP10 4262
Manifold – ERP20 4262
Manifold – ERP30 4262
Manifold – ERP40/45 4262
Reflector Assembly – ERP10 4262
Reflector Assembly – ERP20 4262
Reflector Assembly – ERP30 4262
Reflector Assembly – ERP40/45 4262
Reverb. Screen ERP10 4262
Reverb. Screen ERP20 4262
Reverb. Screen ERP30 4262
Reverb. Screen ERP40/45 4262
Spark Electrode 4262205
Flame Sensor 4262206
Injector No. 41 – Nat.Gas 4262
Injector No. 52 – LPG 4262
8. OPERATING INSTRUCTIONS
8.1 Direct Burner Spark Ignition Models .
8.1.1 Turn on the gas supply to the appliance.
8.1.2 Set any time switch or thermostats to demand heat.
8.1.3 Switch on the electrical supply to the appliance.
8.1.4 The burner should ignite within 25 seconds (Honeywell Control) or 10 seconds (S.I.T Control).
8.1.5 Failure to ignite will result in the ignition controller going to "Lockout" condition.
8.1.6 If 'Lockout' occurs, switch off the electrical supply to the appliance, wait for 10 seconds before switching on the
electrical supply to the appliance to repeat the ignition sequence.
8.1.7 If the appliance fails to ignite after a second sequence, switch off the electricity supply to the appliance and call
the service engineer.
8.1.8 If gas failure occurs after successful ignition, the appliance will attempt one re-ignition before going to
"Lockout" conditions.
8.1.9 To shut down the appliance for short periods of time, switch off the electrical supply to the appliance.
8.1.10 To shut down the appliance for longer periods of time switch off the electrical supply to the appliance and turn
off the gas supply at the gas isolation valve.