SP Scientific FTS FLEXICOOL IMMERSION COOLERS FC100, Руководство оператора

Страница: 24 / 38

SOLO4848 Controller FTS Systems FlexiCool
16 Rev 001, 10/13
© SP Scientific 2013
Up
The Up button is used to increase the value shown on the SV display. Pressing and
holding this button will accelerate the pace at which ascending increments are
displayed.
Down
The Down button is used to decrease the value shown on the SV display. Pressing
and holding this button will accelerate the pace at which descending increments are
displayed.
Auto Tuning
The Auto Tuning LED indicator will flash when the Auto Tuning function is active.
Output 1, Output 2
The Output 1 and Output 2 LED indicators will light when the respective output is
active.
Alarm
The Alarm LED indicator will light when an alarm is activated.
Unit of Temperature (°C, °F)
The Unit of Temperature LED indicates whether the controller is displaying
temperature in degrees Celsius (°C) or degrees Fahrenheit (°F).
Note: For information on changing the temperature display between degrees Celsius to
degrees Fahrenheit, refer to Appendix B: Changing Temperature Display.
Temperature-Controlled Operation
FlexiCool models designed for temperature control feature a proportional-integral-
derivative (PID) microprocessor controller.
Display and Indicators
Process Value (PV) Display
Displays the current nozzle temperature.
Set Value (SV) Display
Displays the desired air temperature, which can be manipulated by pressing the Up
and Down buttons to increase and decrease, respectively, the air temperature and
then pressing SET.
Restarting
Due to the nature of the refrigeration system and its compressor, the FlexiCool should
never be restarted immediately after it is powered off. SP Scientific recommends
waiting approximately five minutes between shutting down and restarting the
FlexiCool.