southpaw enterprises, inc.
®
Instruction Sheet:
303900 Wall Stereo
Store these instructions along with the enclosed maintenance checklist
in a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this
equipment before using. Please file this Instruction Sheet in an accessible
location. The Instruction Sheet must be read and familiar to anyone who is
IMPORTANT: Please check equipment immediately for any damage that may have
resulted during shipping.
MATERIALS
LIST:
TOOLS
NEEDED:
Wall
Stereo
(completely
assembled)
Drill
Remote
Control
1/2”
Drill
Bit
4
Anchors Philip
Screw
Driver
INSTALLATION PROCEDURE:
Position the Stereo on wall where it will be hung and mark mounting holes. Drill holes into wall, set anchors,
position Stereo and secure to wall. Plug Stereo into 110v outlet.
INSTRUCTIONS FOR USE:
The Wall Stereo was intended for use with Southpaw Vibro Acoustic products (Rocker, Wedge, Ball Pool, Pad-
ded Corner, and Waterbed). Any two of these items can be connected to the Wall Stereo at one time. Connec-
tions are best used with the cords supplied with vibro product. Cord has one RCA jack at each end. Plug one
end into the vibro product and the other into the rear of the Stereo rover. If standard speaker wire is used
match the red terminals and the black terminals. Refer to the Stereo instruction manual for operation of Stereo.
For best results, when using vibro products and the external speakers built into the rover use the FADE option
on the Stereo and make the FADE REAR plus 11. Stereo can be used only with CD’s or an MP3 player.
MAINTENANCE CHECKLIST
9
All of the following wear points should be checked on a monthly basis and recorded on the checklist
enclosed:
•
Check for frayed wires
•
Check the wood surface and edges for splinters. If found, discontinue use until repaired. You may repair
it by sanding the area smooth with a medium grit sandpaper, and applying two coats of clear lacquer to
the repaired area.
STORAGE PROCEDURES
•
Store where not accessible by clients without proper supervision.
CLEANING INSTRUCTIONS
•
Check with your infectious disease department before using these procedures.
•
Check for client allergies first.
•
Clean with a damp rag and a mild surface cleaning solution
•
Let air dry or wipe dry with a cloth.
Safety Precautions -
The safety of your clients is dependent on the appropriate choice of activity to match, yet challenge their
physical abilities. Use appropriate spotting / safety techniques. In addition, the layout of your activity area, proper installation and
maintenance of your equipment is critical. Southpaw equipment is not intended for recreational or outdoor use. Under no condition
should this equipment be used without proper supervision.
This sheet is for example only.
It is not meant to, in any way, replace local, county, state, or Federal standards. Be aware - it is
your responsibility to find all pertinent safety information that pertains to your facility.
Southpaw
Enterprises Inc.
®
If you have any questions or comments, please call or write
Southpaw Enterprises, Inc.
P.O. Box 1047, Dayton, Ohio 45401 -1047
Toll Free - (800) 228-1698
Come see us on the World Wide Web at http://southpawenterprises.com
© 2010 Southpaw Enterprises, Inc.
FORM CODE: XI-303900
Step by Step
Drill a 1/2” hole. Hold metal channel flat
alongside plastic straps and slide channel
through hole. Minimum clearance behind
wall is 1-7/8”.
Hold ends of straps between thumb and
forefinger and pull toward you until chan-
nel rests flush behind wall. Slide plastic
cap along straps with other hand until
flange of cap is flush with wall.
Snap straps at wall by pushing side to side
snapping off straps level with flange of
cap.
Place item over flange. Insert bolt through
item and tighten until flush, then stop.
