Quick-Check-PowerSaver Manifold 6 Port South-Tek Systems
Revision: 0
Revision Date: 8/2/17
Page 12 of 30
independently controlled and operated by the PLC based on the O
2
content of the corresponding Zone. Depending
on the Quick-Check series model, procedures for unpacking the equipment(s) may vary.
Exhaust Valve
The exhaust valve is at the end of the manifold block. It is there to purge out the Zone to acceptable O
2
levels.
110-220VAC to 24VDC power converter
The device is setup with a 24 VDC power converter that will accept either 110 or 220 VAC power supply.
4.2
SPECIFICATIONS
5
SYSTEM CONTROLS AND COMMUNICATIONS
The Quick-Check-PowerSaver Manifold comes with controls and instruments uniquely programmed (proprietary to
South-Tek) with a control sequence to effectively and efficiently analyze nitrogen in Fire Protection Systems.
Unauthorized changes to the system will void all warranties and may cause damages to the system or cause it to
malfunction.
Quick-Check-PowerSaver Manifold 6 Port
–
Specifications
Installation
Wall Mount
Display
Zone Purity Status, Alarm Status, Zones, System Status, Power Status
Manifold Port Connections
¼” PTC straight fittings
Electrical
110-220V / 50-60Hz / 1Phase; <2amp
Ambient Temperature
40° to 90°F
Size
12.07" W x 7" D x 13.5" H (Cabinet Dimensions)
Weight
~24lbs
