South bend SB1493, Руководство пользователя

Страница: 15 / 32

South Bend Tools
For Machines Mfd Since 1/21 Model SB1493
-13-
P R E P A R A T I O N
Bench Mounting
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place
Figure 5. "Through Mount" setup.
Machine Base
Workbench
Hex Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers
Machine Base
Workbench
Lag Screw
Flat Washer
Figure 6. "Direct Mount" setup.
Assembly
The machine must be fully assembled before it
can be operated Before beginning the assembly
process, refer to Required for Setup on Page
8 and gather all listed items To ensure the
assembly process goes smoothly, first clean any
parts that are covered or coated in heavy-duty
rust preventative (if applicable)
To assemble machine:
1. Fit (1) 16 x 25 x 8mm T-bushing into each
19 x 32 x 9mm T-bushing, then slide each
bushing pair onto each spindle shaft on
either side of buffer (see Figure 7)
5
/
8
" Hex Nut
Wheel
Flanges
16mm Bushing
19mm Bushing
Note: Left spindle shaft has left-hand
threads.
4.
Once both spindle hex nuts are installed, use
wrench on each to tighten
Figure 7. Buffing wheel installed on buffer.
2. Install (1) wheel flange and buffing wheel
(not included) on each spindle shaft (see
Figure 7)
3. Place (1) wheel flange on each shaft against
wheel, and secure each wheel with
5
/
8
"-11 hex
nut (see Figure 7)