South bend SB1117, Руководство пользователя

Страница: 29 / 48

South Bend Tools
For Machines Mfd. Since 12/20 Model SB1117
-27-
O P E R A T I O N
Figure Figure 35. Belt tracking components. . Belt tracking components.
Tracking Tracking
Adjustment Adjustment
Knob Knob
Jam Nut Jam Nut
!
5. Loosen jam nut shown in Figure 35.
6. Turn tracking adjustment knob
counterclockwise to adjust tracking upward
or clockwise to adjust tracking downward
(see Figure 35).
Note : Adjust tracking adjustment knob in
about 1-turn increments.
7.
Repeat Steps 3
–
6 until belt tracks in center
of drums.
8. Tighten jam nut from Step 5 to secure
setting.
To check/adjust belt tracking:
1. Install desired sanding belt as described in
Installing/Changing Sanding Belts on
Page 24.
2. Pre-track sanding belt as described in Pre-
Tracking Belt on Page 26.
3.
Connect machine to power, press ON button,
then press E-Stop button immediately
after. Sander should run just long enough
to observe belt tracking across drums and
platen.
—
If belt tracks centered on drums, no
adjustment is necessary.
—
If belt does not track centered on drums,
proceed to Step 4.
4.
DISCONNECT MACHINE FROM POWER!
To adjust main table tilt:
1.
Loosen main table tilt lock handles (see
Figure 37).
Figure Figure 37. Location of main table tilt lock handles. . Location of main table tilt lock handles.
Main Table Tilt Main Table Tilt
Lock Handles Lock Handles
Adjusting Main Table
The main table is adjustable to accommodate a
wide range of workpiece and sanding operations.
The table is easily adjusted up and down due
to the special balance mount, and can be tilted
0
°
–45
°
.
Adjusting Main Table Height
Turn main table height handwheel
counterclockwise to raise the table or clockwise
to lower it (see Figure 36).
Figure Figure 36. Location of main table height handwheel. . Location of main table height handwheel.
Main Table Main Table
Height Height
Handwheel Handwheel
Adjusting Main Table Tilt
Tools Needed Qty
Calipers ..................................................................1
Wrench or Socket 17mm .......................................1