South Bend Tools SB1125, Руководство пользователя, Страница: 37 / 56

South Bend Tools
For Machines Mfd. Since 11/21 Model SB1125
-35-
M A I N T E N A N C E
Machine Storage
All machinery will develop serious rust problems
and corrosion damage if it is not properly
prepared for storage. If decommissioning this
machine, use the steps in this section to ensure
that it remains in good condition.
Checking V-Belts
Center
Pulley
Motor
Pulley
¼" Deflection
Spindle
Pulley
Figure 57. Correct belt deflection. Figure 57. Correct belt deflection.
Inspect the V-belts regularly for tension and
damage. Refer to Figure 57 for proper belt
tension. Belt deflection should be approximately
1
⁄
4
" under moderate pressure. If belt deflection is
more than
1
⁄
4
", belt is worn and must be replaced
(refer to Replacing V-Belts on Page 37).
Preparing Machine for Storage
1. Put on safety glasses
2. Coat rust preventative with cleaner/
degreaser, then let it soak for 5–10 minutes.
3. Wipe off surfaces. If cleaner/degreaser is
effective, rust preventative will wipe off
easily.
4. Repeat
Steps 2–3 as necessary until clean.
5. Install/tension V-belts as described in
Replacing V-Belts on Page 37.
6. Perform Test Run and Spindle Break-In
beginning on Page 19.
1. Disconnect all power sources to machine.
2. Thoroughly clean all unpainted, bare metal
surfaces, then coat them with light weight
grease or rust preventative. Take care to
ensure surfaces are completely covered but
that grease or rust preventative is kept off of
painted surfaces.
Note: If machine will be out of service for
short period of time, use way oil or good
grade of medium-weight machine oil (not
auto engine oil) in place of grease or rust
preventative.
3. Loosen or remove V-belts so they do not
stretch while machine is not in use.
4. Completely cover machine with tarp or
plastic sheet that will keep out dust and
resist liquid or moisture. If machine will be
stored in/near direct sunlight, use cover that
will block sun's rays.
Bringing Machine Out of Storage
Items Needed Qty
Mineral Spirits ......................................As Needed
Shop Rags ..............................................As Needed
Rust Preventative .................................As Needed
Tarp/Plastic Sheet .................................................1
To prepare machine for storage:
Items Needed Qty
Safety Glasses .................................................1 Pr.
Cleaner/Degreaser ................................As Needed
Shop Rags ..............................................As Needed