South Bend Tools SB1125, Руководство пользователя, Страница: 20 / 56

-18-
For Machines Mfd. Since 11/21
South Bend Tools
Model SB1125
P R E P A R A T I O N
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Required for Setup on Page
10 and gather all listed items. To ensure the
assembly process goes smoothly, first clean any
parts that are covered or coated in heavy-duty
rust preventative (if applicable).
To assemble machine:
1. Thread (3) downfeed handles onto (3)
downfeed levers (see Figure 16).
Note: Lever end with notch should face away
from handle.
2. Thread (3) downfeed levers into hub on side
of headstock (see Figure 16).
x 3
Hub Hub
Figure Figure 16. Downfeed handles and levers installed. . Downfeed handles and levers installed.
Joining Drill Chuck
& Arbor
An arbor is included for the drill chuck that
comes with this machine. The following
procedure describes how to install the arbor in
the chuck.
After the arbor is installed in the drill chuck, it
is very difficult to separate the assembly. If you
would like to use a different chuck in the future,
we recommend obtaining a new arbor.
IMPORTANT: DO NOT install the drill chuck and
arbor assembly into the spindle until AFTER the
test run.
To join drill chuck and arbor:
1. Use acetone or lacquer thinner to clean drill
chuck and arbor mating surfaces, especially
the bore.
2. Retract chuck jaws completely into chuck.
3. Insert small end of arbor into chuck.
4. Hold assembly by the arbor and tap chuck
onto a block of wood with medium force, as
illustrated below.
5. Attempt to separate drill chuck and arbor by
hand —if they separate, repeat Steps 3–4.
Figure 15. Joining drill chuck and arbor. Figure 15. Joining drill chuck and arbor.