ST2523 Series Operation Manual Ver1.2
10
Operation procedures are as follows:
Move to the RANGE zone, the following items will be displayed:
AUTO Set the range mode as auto.
HOLD Switch the range mode from auto to HOLD. Since the range mode is set to HOLD, the
current measurement range will be locked and displayed in the RANGE zone.
↑(+)
Increase the range.
↓(-) Decrease the range.
3.1.3
Measurement Speed
The measurement speed of ST2523 is decided by the following factors:
Integral sampling period
Average times (measurement times)
Measurement delay time ( a time starting from the measurement start-up to the measurement
beginning)
time showing measurement result
Four measurement speeds are available on ST2523: FAST (fast, approx. 50meas/ sec), MED (medium, approx.
10meas/ sec) and SLOW (slow, approx. 6.25meas/ sec).
Operation procedures are as follows:
The measurement result is displayed as a 5-digit number in decimal point floating mode. The impedance
parameter is displayed in fixed decimal point mode, while the inductance parameter is displayed in floating
decimal point mode.
1)
Move the cursor to the SPEED zone, the following items will be displayed in the soft key zone.
FAST (fast)
MED (medium)
SLOW (slow)
N
NN
O
O
O
T
TT
E
EE
:
::
Measurement speed:
when the measurement speed is selected as SLOW or MED, the measurement
result will be a 5-digit number, while in FAST speed it is a 4-digit number.
3.1.4
File Manage
1) INTER File
2) EXTER File
3.1.5
TOOLS
Operation procedures are as below:
Move to the TOOL zone, the following menus will be displayed in the soft key zone.
REL OFF (Relative function on /off. When OFF is selected, Relative function will be disabled; when
ON is selected, Relative function will be enabled.)
SHORT OFF (Choosing OFF to turn off the short function, while choosing ON to turn it on.)
SHORT (Execute the short zero adjustment)
DISP ON (Display the measure result on full screen mode. Press any key (except TRIGGER) to exit.)
