INSTALLATION AND MOUNTING:
2
You must first attach the mounting tabs to the capacitor before mounting
it. Use the supplied hardware shown in the picture to the right. Notice the
small mounting screw hole in the capacitor chassis.
CHARGING THE CAPACITOR AND WIRING:
The capacitor must be charged before connecting the Power and Ground
cables to the capacitor. Failure to charge the capacitor will result in a
large spark generated from the rapid inflow of current.
DISCHARGING THE CAPACITOR:
To Charge the capacitor:
1.
2.
3.
4.
When you want to take out the capacitor after you finish the installation
process from original car audio system. You must do discharge process
when you want to move the capacitor. It will be safe to release the
power of the capacitor.
3
Make Capacitor positive terminal connections with amplifier and
tighten the bolt. Do not over-tighten the bolts!
Connect the ground cable with battery, amplifier, then refer to the
attached drawing.
Place the supplied charging bulb between positive terminal of the
capacitor and the battery's positive terminal. Do this for 2 ~ 3
minutes or until the charging bulb goes out.
Immediately take out the charging bulb from the connecting wire
after the charging process. And connect the positive cable of the
battery directly to the positive terminal on the capacitor.
Caution:
Stripped terminals are not covered under the capacitor's warranty.
Caution:
The charging bulb will get hot!
