soundsation ZEUS II H-2600QX, Руководство пользователя

Страница: 8 / 44

8
ENGLISH
ZEUS II H-QX series User manual
7)^POWER Switch
Press the switch to the (1) position to turn ON the amplifier and to the (0) position to
turn it OFF.
Note: When the power switch is turned OFF, the device is not completely
disconnected from the mains. So if the amplifier is not used for a long time,
please disconnect the power cord from the outlet.
8)^FRONT PANEL VENTILATION grille
It allows constant ventilation between the front and back of the amplifier. This series
amplifiers pull air from the rear, and exhaust it from the front, thus allowing the heat to
dissipate without heating the rack. When the amp works harder, the fan will speed up
and expel more hot air. It is suggested not to obstruct this grill.
5. REAR PANEL
CH3 OUTPUT
CH4 OUTPUT
CH1 OUTPUT
CH2 OUTPUT
AC 220V - 50/60Hz
LIMITER
OFF ON
SUBWOOFER LOWCUT OFF
1,4V 2,5V 0,775V
PARALLEL STEREO BRIDGE
1,4V 0,775V 2,5V
ON OFF
Processing
SUBWOOFER LOWCUT OFF
LIMITER
ON OFF
LIMITER
OFF ON
SUBWOOFER LOWCUT OFF
1,4V 2,5V 0,775V
PARALLEL STEREO BRIDGE
1,4V 0,775V 2,5V
ON OFF
Processing
SUBWOOFER LOWCUT OFF
LIMITER
ON OFF
CH3 LINK CH1
ON
OFF
CH4 LINK CH4 INPUT CH3 LINK CH3 INPUT CH2 LINK CH2 INPUT CH1 LINK CH1 INPUT
GROUND
LIFT
25
45
90
125
150
Hz
25
45
90
125
150
Hz
25
45
90
125
150
Hz
25
45
90
125
150
Hz
FREQUENCY
FREQUENCY FREQUENCY
FREQUENCY
1 2 2
2
3 4 5 7
2 9 10 11 10 11 10 9
4 1 1 1 5
10 9 9
6
8
8
8
1)^INPUT AND LINK CONNECTORS
Each channel has one balanced female XLR connector, which accepts a XLR plug from
almost any type of equipment with a balanced or unbalanced outputs.
The male LINK connectors are connected in parallel with the respective INPUT, so the
LINK is wired at the same way.
Note: Whenever possible, always use balanced cables. Unbalanced cables can
also be used, but there may be noise problems. In any case, avoid using a
balanced cable for one channel and one unbalanced for the other.
2)^OUTPUT CONNECTORS
Each channel has one Speakon® output for connecting to the loudspeakers.
CH1 and CH3 provide “4-wire” access to both channels using the standard convention:
CH1 uses 1+, 1-. and CH2 uses 2+, 2-.
CH3 uses 1+, 1-. and CH4 uses 2+, 2-
CH2 and CH4 provide “2 wire” access respectively to CH2 and CH4 only, using 1+, 1-.