1.800.338.7337 / www.soundoffsignal.com
1
EL3PHØ2AØ+(X) 0919
!
WARNING
This product contains high intensity LED devices.
To prevent eye damage, DO NOT stare into the
light beam at close range.
INSTALLATION:
Important: DO NOT over tighten
mounting screws or nuts. This could
cause permanent damage to the unit.
Use hardware supplied for mounting.
1. Assemble the UltraLITE as shown in
the exploded illustration by inserting
the carriage bolt in the channel on the
back of the light.
2. Install the pivot block and the angular
adjustment arm on the bolt and
loosely secure with a nut.
3. Install the head adjustment arm as
shown and lightly secure with nut.
4. Snap suction cups into place.
5. Press suction cups to windshield
assuring that unit is not located
where it obstructs the driver’s vision
or in the area of air-bag deployment.
6. Make sure the light is horizontal and
carefully tighten all nuts.
7. Plug cigarette plug into receptacle
and refer to operation instructions to
activate light.
For your convenience a universal
bracket is supplied if a deck mount
application is desired.
WINDSHIELD LIGHT
EL3PHØ2AØ+(x)
PATTERN SELECT - ON/OFF SWITCH
12V ADAPTOR
SUPPLIED BAR MOUNTING HARDWARE
UNIVERSAL BRACKET
SUCTION CUP
PIVOT BLOCK
ANGULAR ADJUSTMENT
HEIGHT ADJUSTMENT
ULTRALITE PLUS
INTERIOR WARNING BAR
NOTICE:
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/tech-services/returns/
.
If you have questions regarding this product, contact
Technical Services
, Monday - Friday, 8 a.m. to 5 p.m. or after hours 5 p.m. to 8 p.m. ET at
1.800.338.7337
(press #4).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
Please see reverse for Technical Specifications
•HIGH CURRENT interconnects must be properly terminated. Poor crimp quality can cause heat build-up and fire. Follow crimp connec
-
tor manufacturer instructions.
•DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to vehicle Owner’s Manual for deployment zones.
•Do NOT use system to disconnect headlights, brake lights or other safety equipment.
•Unit may become hot to touch during normal operation.
•Failure to properly install connectors, fuses or wiring may cause vehicle failure or fire.
•Installation must only be performed by trained technician. Installer must determine vehicle wiring configuration and proper integration
of system.
•Use proper wire gauge. All power wires connecting to positive (+) or negative (-) battery terminal or local chassis ground (-) must be
sized to supply at least 125% of max. current and properly fused at power source.
•Install protective grommets when routing wire through firewall or metal.
WARNING
