SCD1700
/ English Instruction Manual
3
Preset store
1. Select the desired radio station.
2. Press and hold
the “
MODE / PROG
” button until “Preset store” is shown in the display.
3. C
hoose with “
SKIP- / TUNE-
” or “
SKIP+ / TUNE+
” the desired program station number.
4.
Press to confirm “
STOP / ENTER
”. “Preset X stored” is shown in the display (X = station
number).
Preset recall
1.
Press the “
MODE / PROG
” button. “Preset recall” is shown in the display.
2. Select with
“
SKIP- / TUNE-
” or “
SKIP+ / TUNE+
” the desired stored radio station.
3.
Press to confirm “
STOP / ENTER
”.
DAB information
Press repeatedly the
“
MENU / INFO
” button to show the following DAB information:
DLS, signal strength, genre, multiplex, frequency, signal error, audio bit rate, time, date.
DAB menu
To enter the DAB menu, press and hold
the “
MENU / INFO
” button. Select with the “
SKIP- /
TUNE-
” or “
SKIP+ / TUNE+
” one of the following settings and press “
STOP / ENTER
”:
•
Full scan:
Starts the station scan. The DAB frequency band is scanned for stations.
•
Manual tune:
To do so you need to know the station frequency. This can be found on the internet site of
the broadcasting service. Select individual frequencies using the
“
STOP / ENTER
” button.
•
DRC:
Short for Digital Range Control (dynamic range). The term DRC describes the ratio between
the quietest and the loudest sound. If the dynamic range is very high there are very soft
sounds as well as very loud sounds.
Under some circumstances this may present a problem with playback. Let us assume that
you are listening to a radio station in a relatively loud environment. By increasing the volume
you can play the quiet sections louder.
This however has the disadvantage that the loud sections become uncomfortably loud. It
makes sense here to reduce the dynamic range. Select between the options:
-
DRC off: The dynamic range is not reduced.
-
DRC high: The dynamic range is sharply reduced.
-
DRC low: The dynamic range is slightly reduced
•
Prune:
It may be that you can no longer receive some stations after a station scan or change of
location. With this function you can delete these stations from the reception list. Select
“YES” and confirm with the “
STOP / ENTER
” button.
