5
IMPOR
IMPOR
IMPOR
IMPOR
IMPORT
T
T
T
TANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONS
ANT SAFETY INSTRUCTIONS
CAUTIONS
•
To avoid the risk of fire, replace the mains fuse only with the correct type and value
fuse, as marked on the bottom of the product.
•
ATTENTION: - Afin de réduire le risque de feu remplacer seulement avec fusible de
même type.
•
MAINS VOLTAGE SELECTION
This setting is NOT User Adjustable.
The units are capable of operating at either 230V AC or 115V AC mains voltages ±10%.
•
REPLACING MAINS FUSE
Remove the mains lead from the connector. Use a small screwdriver to unscrew the
fuse carrier from its location to the left of the mains power connector. Check the fuse is
of the correct type and value and replace if necessary; also check that the voltage
selection as marked on the rear panel is correct for the mains supply level before
switching the unit ON again.
If the mains fuse fails repeatedly this may be because an electrical safety hazard
exists. The unit must be taken out of service and referred to the Soundcraft dealer from
where the equipment was purchased.
•
THIS UNIT MUST BE EARTHED
Under no circumstances should the mains earth be disconnected from the mains lead.
•
ATTENTION: - Cet appareil doit être branché à la terre.
The wires in the mains lead are coloured in accordance with the following code:
Replacement Part No: FJ8016 (UK) : FJ8017 (EU) : FJ8018 (US & CAN)
UK & EU
US & CAN
Earth / Ground:
Green and Yellow
Green and Yellow
Neutral:
Blue
White
Live:
Brown
Black
As the colours of the wires in the mains lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in the
plug which is marked with the letter E or by the earth / ground symbol:
The wire which is coloured Blue or White must be connected to the terminal in the plug
which is marked with the letter N.
The wire which is coloured Brown or Black must be connected to the terminal in the
plug which is marked with the letter L.
Ensure that these colour codings are followed carefully in the event of the plug being
changed.
•
Do not install near any heat sources such as radiators, heat resistors, stoves, or other
apparatus (including amplifiers) that produce heat.
