SoundCraft DC 2020, Руководство пользователя

Страница: 61 / 190

from each Input Module: they are both switched (together) by the POST switch on
each Input Module.
Signals from Stereo Input Modules
8
When the STEREO switch is released, Mono signals (L+R) from the Stereo
Input channels are connected to both the FB1 and the FB2 channels. The level of
the signal from each of the Stereo Inputs is controlled by the FB1/L and FB2/R level
controls on each of the Stereo Inputs.
When the STEREO switch is depressed, the Left signals from the Stereo inputs are
connected to the FB1 channel and the Right signals are connected to the FB2
channel. Again, the level from each of the Stereo inputs is controlled by the FB1/L
and FB2/R level controls.
Note: When the STEREO switch is depressed it is recommended that the CH/MON
switch is also depressed.
Note: The Foldback Master panel mixes the signals from all of the Input Modules
and the Stereo Input Modules. The relative level of each depends upon the setting
of the Level control on each individual module.
9
After mixing the Foldback signals are fed through their respective faders,
FB1/L and FB2/R.
From this point in the description only one of the two Foldback channels will be
described.
10
After the fader there is an electronic cut switch. This is controlled by the
Automation. The Automation also reads the state of the CUT switch, and controls
the state of the adjacent CUT LED and the ARM LED.
The Automation Operates the Cut as follows:
11
The AFL switch connects the post-fade post-cut signal to PFL/AFL bus. The
position of this switch is also read by the Automation: the Automation switches the
Control-room Phones/Speakers to listen to the PFL signal.
DC2020 Studio Outputs & FB Masters 4.21