SoundCraft D-MIX 1000, Руководство пользователя

Страница: 27 / 38

8
The PEAK LED warns the DJ of excessive signal level in the channel before
distortion occurs. The signal is sampled just after the EQ section, and illumination
of the LED will indicate that the input sensitivity is set too high, or that the EQ
settings are too extreme.
Channel Output
9
The channel signal may be assigned directly to the main L/R mix, or may be
switched to either the A or B side of the Crossfader which enables smooth transitions
between selected sources. The routing switches are interlocking.
10
The output signal level from the channel is set by the long-travel FADER. If
the channel input is selected to MIC, moving the fader from the end stop will also
cause the DJ Booth monitors to be muted when a Cue is active, to prevent feedback.
11
The large illuminated CUE switch enables the pre-fade channel signal to be
routed to the DJ’s headphones and the booth monitors if required. The mono
channel signal is sent equally to both sides of the stereo Cue mix, and is not affected
by the position of the Pan control.
Jumper Options
J1A Fit to d48V phantom power to the Mic input XLR. (Default)
J1B Fit to 48V phantom power to the Mic input XLR.
J2A Fit in position A to enable Voice-Over. (Default)
J2B Fit in position B to disable Voice-Over.
J3 Fit in position A for Aux source pre-fade (Default)
Fit in position B for Aux source post-fade
Rear Connector Panel
Mic/Line Input Module 4.3