Headphone jack
OutCast Installation:
5
1. OutCast bottom view.
Remove battery cover screws.
2. OutCast unit with battery cover
removed.
Connect battery. Be careful to
Connect battery
Connect battery
orient connector
properly so it easily snaps into place.
3. OutCast with battery installed
carefully screw cover back in place.
If you wish to connect your iCast Transmitter to a set of
headphones or to some external self-powered speakers, you may
do so by inserting the plug on these devices into the headphone
jack on the back of the iCast Transmitter. Please remember that
the volume control on your iPod does not function while in the
dock, so you can only adjust the volume if the headphones or
external powered speakers permit it.
Note:
iCast units do not have an internal amplifi er. Any speaker
Then insert the battery as shown (there is only one way the battery will fi t properly due to the cable length) and
replace the screws to secure the cover. There is a safety interlock in the OutCast battery cover, so the cover must
be screwed into place for the OutCast to operate.
systems that are attached to this product must have internal amplifi ers in order to play music.
Connect the power cord to the three prong outlet on the back
of OutCast and connect the plug into an AC outlet. Remove
the protective plug from the AC power socket on the lower
back section of OutCast and then connect the power cord to
the three prong socket. Insert the power cord plug into an AC
outlet. This will supply AC power to your OutCast and will also
charge the battery pack. You should charge the battery pack
for at least 3 hours before attempting to operate OutCast on
battery power alone. Once the battery has been discharged,
it will take about two to three hours to fully charge the battery
if the power switch on OutCast is off. If you are charging
while the unit is playing, it will take a bit longer. The battery
will slowly discharge if left off for several weeks. In very hot
climates this will happen more quickly. You must fully charge
the battery again for best performance if your OutCast has not
been used for some time. When operating your OutCast on battery power, please replace the protective safety
plug back over the AC socket to prevent moisture from entering the socket.
The OutCast unit will be controlled by the buttons on top. There is a green power indicator light on the right side
of OutCast that indicates that the unit is turned on. When the power button on top of the unit is pressed, the light
will come on. If there is a red light on the left side, it means the battery needs to be charged. The red light will
fl ash slowly when the battery is low, stay on the when battery is discharged, and it will go out completely when
the battery is fully charged. When the power cord is inserted, the red light will fl ash rapidly for a few seconds,
while the circuit self tests to check the battery charge condition. This is normal. If the battery needs charging,
then the red light will stay on until the charging cycle is completed.
The button on the far right is the mood lighting on/off switch, the next two buttons are volume up and down, and
the center button is power on/off. The buttons on the left are iPod control buttons – pause/play, track back and
Содержание OutCast
Страница 1: ...OUTCAST OWNER S MANUAL With iCast...
