© 2021 SOTECC GmbH. All rights reserved Rev. 1.3
Handbook/Installation instructions
Canopy flash
14
8.5
Canopy-power interface counterpart attachment with template
Tip: Sometimes this step is easier when sitting inside the
cockpit.
Now close & lock the canopy and place the contact with the
doubled-sided tape flat on to instrument panel cover and
press it on. Then tighten the two screws to avoid movement
of the canopy-power interface on the bracket. Open the
canopy carefully and make sure, that the template does not
get out of place.
8.6
Installation of the counterpart to the instrument panel cover
Remove the panel cover for this step.
Fix the template by drilling two 2,5mm holes and screw
it tight. Now mill out the inner part of the template,
either with a milling tool or with two drills. (7mm left
and right and 10mm in the middle)
If necessary, finish it with a round file, then remove the
template (keep the screws).
Put the counterpart cable through the panel. Use the
plastic component (looks quite similar to the template)
and tighten the screws (already used for the template).
Caution: Red/plus must be to the front inflight direction. Or take heed of the white dot,
they have to lie on top of each other.