© 2021 SOTECC GmbH. All rights reserved Rev. 1.3
Handbook/Installation instructions
Canopy flash
18
9
SOTECC-Configurator
With the supplied SOTECC configurator, it is possible to configure the canopy flash via the connectBOX
individually. You can find the program attached on the supplied USB-stick. The following values can be
changed:
-
Flash frequency
-
Alarm-level threshold
-
LED
-
Baud rate
9.1
Establish connection
To configure the canopy flash via the connectBOX, connect the micro USB-cable to its designated port
on the box, ensure power e.g. aircrafts on-board power supply, start the SOTECC configurator, select
the COM-port, press „connect“ and wait for connection (2-5 sec). If there is no COM-port indicated on
the upper left side of the program, you may try to
-
Connect onboard power supply, switch batteries on
-
Load USB-drivers, which should be done automatically, if there is a connection to the internet
(duration is about one minute)
After successful connection, you will see the current (default) parameters and „connected“ in green
next to the „connect“ button. If there is no response after 5 seconds, you may try to
-
Select the correct COM-port
-
Retry to load the USB-drivers