SORG Jump beta, Руководство пользователя

Страница: 34 / 44

Jump beta
34
3.15.1 Setting the back angle
The back angle is set by us ex works according to
the terms from your therapist/rehab technician.
ATTENTION
It is important that you let your qualified rehab
technician carry out any changes.
3.15.2 Adjusting the back angle
To adjust the back angle:
(5+6) loosen the locking bolts (A) on both sides with
the cable control and adjust the back in small raster
steps (B) from 80° to 120° to the wanted angle.
To fold down the back:
with the ring (C) pull on the cord and loosen the
locking bolts on both sides and fold the back forward.
The raster bolts must go in to the last hole.
Be sure that both bolts (A) are secure in the raster
holes (B) . They must visually stick out of the angle
element (D) .
To undo the angle adjustments proceed in the same
manner.
3.15 Back
There are three different kinds of backs:
• (2) standard
• (3) settable back angle
• (4) adjustable back angle
You do not have to change anything with the standard
back as well as with the settable back.
ATTENTION DANGER OF TIPPING OVER
With the back angle you influence the centre of
gravity of the wheelchair and with it its tilting
behavior.
(6)
(A)
(C)
3.14 Anti-tipper
(1) To activate push the anti-tipper (A) down using
the tread element (B) , turn it 180° and let go so the
positioning slot snaps into the arresting bolt (C) inside
the pipe.
To deactivate push the anti-tipper on the pipe (A)
slightly further down, turn it 180° and let go so it
snaps into the positioning slot.
ATTENTION
Please read the respective chapters of the SAFETY
INTRUCTIONS.
ATTENTION
Make sure that the extension is always firmly
snapped into its final position because a loose an-
ti-tipper cannot fulfil its function properly and may
cause injuries of the assistant’s ankle area.
(2)
(3)
(4)
(B)
(C)
(C)
(A)
(5)
(B)
(C)
(A)
(1)