ENGLISH
35
Quickie Life Rev.4.0
Lower leg length
(Fig.6.16)
By undoing the clamp screw (1), you can adjust the lower leg
length. Loosen the clamp screw, adjust the tube with the
footboard to the desired position.
Tighten clamp screws again (see the page on torque). Ensure
that the plastic push joint is located under the clamp screw in
the correct position.
Ensure that the plastic push joint is located under the clamp
screw in the correct position.
WARNING!
•
Attendant: Do not stand on the footboard! Even if the user
is sitting in the chair, there is still a risk of tipping over and
injury.
•
User: When transferring, do not stand on the footboard,
there is a risk of tipping over and injury.
Option Elevating legrest
(Fig.6.17-6.19)
To remove, pull the lever (1), swing the footplate outwards and
then lift the legrest out.
Height Adjustment:
The lower leg length can be adjusted infinitely by releasing the
screw (2). Adjust the suitable height and tighten the screw
again.
CAUTION!
The distance between the footplate and the ground must be at
least 40 mm.
Angle Adjustment:
Press the lever (3) downward with one hand while supporting
the legrest with the other hand to take the load off. When a
suitable angle is achieved, let go of the lever and the legrest will
lock into one of the preset positions.
WARNING!
•
Keep hands clear of the adjustment mechanism between
the frame and the movable parts of the footrest while
elevating or lowering the footrest.
•
The footrests should not be used to lift or to carry the
wheelchair.
•
Risk of trapping fingers!
•
When moving the footrest up or down, do not put your
fingers in the adjusting mechanism between the moving
parts of the footrest.
FIG.6.17
1
2
FIG.6.18
3
FIG.6.19
Fig. 6.16
1
Lightweight footrest
The footrest angle can be adjusted by loosening the screws (2).
Side protection panels can be fitted to the footrest using the
mounting holes (3). These prevent the feet slipping off
accidentally, (Fig. 6.15). Make sure that after any adjustment
work, all screws are tightened correctly (see the page on
torque).
Fig. 6.15
2
2
3
3
