Connection example
Notes on the control leads
• The power antenna control lead (blue) su12 V DC when you turn on the tuner or when you activate the ATA
(Automatic Tuner Activation) Function.
• A power antenna without relay box cannot be used with this unit.
Memory hold connection
When the yellow power input lead is connected, power will always be supplied to the memory circuit even when the ignition key is
turned off.
Notes on speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Otherwise, the speakers may be
damaged.
• Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with
those of the left speaker.
• Do not attempt to connect the speakers in parallel.
• Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Doing so may damage the
active speakers. Therefore, be sure to connect passive speakers to these terminals.
After connecting, bundle up the connecting cord of the
rotary commander with other connecting cords of the
audio equipment by attaching the supplied cramper
!¡
. Be
sure to leave some slack in the connecting cord between
the plug and the cramper.
BUS CONTROL IN
Max. supply current 0.1 A
Right
Left
Right
Left
Front speakers
Rear speakers
to the +12 V power terminal which is energized in the accessory
position of the ignition key switch
Be sure to connect the black ground to it first
to the +12 V power terminal which is energized at all times
Be sure to connect the black ground to it first
to a metal point of the car
First connect the black ground lead, then connect the yellow and
red power input reads.
BUS AUDIO IN
from car antenna
Fuse (10 A)
Power amplifier
Rear speakers
Blue/white striped
Max. supply current 0.3 A
Front speakers
AMP REM
ANT
ANT REM
REAR LINE OUT
Power amplifier
Blue
Red
Yellow
Black
White striped
Gray striped
Green striped
Purple striped
Light blue
TEL MUTE
to the interface cable of a car telephone
8
to the power antenna control lead or power supply lead of antenna
booster amplifier
<Note> In case of without power antenna, or antenna booster, not
necessary to connect this lead.
FRONT LINE OUT
REMOTE IN
To AMP REMOTE IN of an optional power amplifier.
This connection is only for amplifiers. Connecting any other system may damage the unit.
Source selector
∗
1
RCA pin cord (not supplied)
∗
2
BUS cable with RCA pin cord (not supplied)
∗
3
Supplied to the CD/MD unit
∗
1
∗
2
CD/MD unit
Orange/white striped
ILLUMINATION
to car's illumination signal
!¡
∗
3
∗
3
CD/MD unit
Active subwoofer
SUB W.OUT
∗
1
