Sony XR-C5100, Руководство по обслуживанию

Страница: 2 / 34

– 2 –
TABLE OF CONTENTS
1. GENERAL
Location of Controls ....................................................... 3
Resetting the Unit ........................................................... 4
Detaching the Front Panel ............................................... 4
Setting the Clock ............................................................. 4
Installation ....................................................................... 5
Connection ...................................................................... 7
2. DISASSEMBLY
......................................................... 9
3. ASSEMBLY OF MECHANISM DECK
............ 11
4. MECHANICAL ADJUSTMENTS
....................... 14
5. ELECTRICAL ADJUSTMENTS
Test Mode ........................................................................ 14
Tape Deck Section .......................................................... 14
Tuner Section .................................................................. 15
6. DIAGRAMS
6-1. IC Pin Function Description ........................................... 17
6-2. Printed Wiring Board –MAIN Section– ........................ 21
6-3. Schematic Diagram –MAIN Section– ........................... 23
6-4. Printed Wiring Board –PANEL Section– ...................... 27
6-5. Schematic Diagram –PANEL Section– ......................... 29
7. EXPLODED VIEWS
................................................ 33
8. ELECTRICAL PARTS LIST
............................... 36
Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270 ˚C dur-
ing repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
Power amplifier section
Outputs Speaker outputs
(sure seal connectors)
Speaker impedance 4 – 8 ohms
Maximum power output 40 W
×
4 (at 4 ohms)
General
Outputs Power antenna control
lead/Power amplifier
control lead/Telephone
ATT control lead (E model only)
Rear line out (1)
Tone controls Bass ± 8 dB at 100 Hz
Treble ± 8 dB at 10 kHz
Power requirements 12 V DC car battery
(negative ground)
Dimensions Approx. 188
×
58
×
181 mm
(7
1
/
2
×
2
3
/
8
×
7
1
/
4
in.)
(w/h/d)
Mounting dimensions Approx. 182
×
53
×
164 mm
(7
1
/
4
×
2
1
/
8
×
6
1
/
2
in.)
(w/h/d)
Mass Approx. 1.2 kg (2 lb. 10 oz.)
Supplied accessories Parts for installation and connections (1 set)
Front panel case (1)
Design and specifications are subject to change without notice.