31
Supplying Power / Initial Setup
Chapter
Chapt
er
3
Pre
par
at
ion
s
3
Preparations
Supplying Power
Connect the AC power input connector to an AC power
source using the specified AC power cord. To supply
power, set the main power switch on the rear panel to on,
and then press the on/standby (
1
) button on the front panel
and hold it down for a short time (0.25 seconds or longer).
To switch the state of this unit from standby state (the main
switch on the rear panel is on) to operative state, wait at
least three seconds after the unit has entered standby state
and then press the on/standby button on the front panel.
Initial Setup
This unit is shipped with the area of use, system frequency,
and current date and time still unset.
Therefore, you need to make initial setup settings before
using the unit. (You cannot use the unit without setting it
up.)
Once the unit has been set up, the settings are retained even
when the unit is powered off.
To set the area of use and system
frequency
1
Power the unit on.
The INITIAL SETUP screen appears on the display.
Note
