Sony XDCAM PMW-1000, Руководство по эксплуатации

Страница: 36 / 111

36
Basic Operations of the Function Menu
Ch
apt
er 3 Prep
ara
tio
ns
a) To enable this setting, the following settings are also required, in the same
way as for volume operations for channels 1 to 4.
• Set the VARIABLE switch of the front panel to “REC” or “PB”.
• Set setup menu item 131 AUDIO VOLUME to “each”.
P4 TC page
P5 OTHER page
a) The target operation mode is set using setup menu item 108 AUTO EE
SELECT.
F4: A8 VOL Sets the volume of audio channel 8.
a)
The volume can be adjusted within the
range from
–200 to 0 to +200 (–
∞
to
+12 dB) by turning the PUSH SET knob.
The volume changes in steps of ±10 if you
hold the SHIFT button down while you turn
the knob.
F5: – (Unassigned function button)
F6: – (Unassigned function button)
Item Setting
F1: TCG Selects the timecode signal to which the
internal timecode generator synchronizes.
INT: Follow the initial value set from the
front panel or remotely from the
device connected to a REMOTE (9P)
connector.
EXT: Synchronize to external timecode
signal input to the TIME CODE IN
connector.
SDI: Synchronize to timecode embedded
into HDSDI or SDSDI signal input to
the SD/HDSDI INPUT connector.
F2: PRST/RGN Selects the following for the internal
timecode generator.
PRESET: Presets an initial value for the
timecode generated by the internal
timecode generator, as specified from
the front panel or remotely from the
device connected to a REMOTE (9P)
connector.
TC: Generate timecode synchronized to
timecode read by the internal
timecode reader.
VITC: Generate timecode synchronized to
VITC read by the internal timecode
reader.
F3: RUN
MODE Selects the timecode run mode.
FREE RUN: Timecode advances as long
as the unit is powered on, regardless
of the unit’s operating state.
REC RUN: Timecode advances only
during recording. When you select this
item, also set F1: TCG on this page to
“INT” and set F2: PRST/RGN to
“PRESET”.
F4: DF/NDF Selects the frame count mode for the
internal timecode generator and the
counter in 59.94i/59.94P/29.97P mode.
DF: Drop-frame mode
NDF: Non-drop-frame mode
Item Setting
F5: PDPSET When the system frequency is set to 1080/
59.94i, 1080/29.97P, or 720/59.94P,
presets the timecode of the A frame of the
pulldown sequence.
24F TC: Reference timecode for A frame
30F TC: Timecode after pulldown
conversion from 24-frame timecode
F6: TCR Selects the type of timecode to display in
the time data display area.
TC:
Display TC.
VITC: Display VITC.
Item Setting
F1: INDEX Sets the index picture (thumbnail) of a clip
being played back
(see page 60) .
F2: ERR LOG Displays the error log screen.
F3: CREATE
NEW EDL Creates a new EDL (see page 61) .
F4: ADD TO
CURT.EDL Adds a sub clip to the current EDL (see
page 62) .
F5: PB/EE Selects the video and audio signals that
are output in stop, forward direction high-
speed search, and reverse direction high-
speed search modes
a)
.
PB: Playback signal
EE: EE mode signal
F6: – (Unassigned function button)
Item Setting