XBR-65X900A 25
SECTION 3 - REPAIR INFORMATION
REMOVING THE SIDE SPEAKERS
1. Remove 14 screws from Speaker Cover, lift as shown to disconnect
connector from PWB Board, then slide it through the Speaker Cover
opening to detach.
NOTE: Use a 7mm Metric Nut Driver to remove:
Spacer (SP-RC), HEX.
2. Locate and remove 2 screws from PWB Board, then release harness to
detach.
PWB Board
PWB Board
3. Carefully disconnect all remaining connectors from PWB Board and lift to
detach.
4. Lift Speaker (80MM) to detach. Release 2 locking clips to remove
Speaker Bracket and lift Speaker Ornament to detach.
Speaker (80MM)
Speaker (80MM)
Speaker
Bracket
Speaker
Bracket
Speaker
Ornament
Speaker
Ornament
5. Remove 2 screws from Speaker (18MM) and lift to detach.
Speaker (18MM)
Speaker (18MM)
6. Remove 2 screws from TW Bracket and lift to detach.
TW Bracket
TW Bracket
7. Lift Loud Speaker to detach. Release 2 locking clips to remove Speaker
Bracket and lift Speaker Ornament to detach.
Loud Speaker
(Passive Radiator)
Loud Speaker
(Passive Radiator)
Speaker
Bracket
Speaker
Bracket
Speaker
Ornament
Speaker
Ornament
8. Refer to these instructions to remove the opposite Side Speakers.
