XBR-65X900A 24
SECTION 3 - REPAIR INFORMATION
20. Install the Software.
a. Press
POWER
to turn TV OFF.
b. Wait 5 seconds and insert the USB device with the latest
Software into the TV.
NOTE:
Display will not be shown on the TV during the update.
If the USB drive has an indicator light, it will start blinking.
CAUTION: Must use the same version as the first update.
c. Wait aproximatelly 5 minutes, until TV turns ON and a successful
update message appears.
d. Remove USB device.
REPLACING THE SWITCH UNIT
1. Disconnect 2 connectors from the Switch Unit, then remove 2 screws
and lift to detach.
2. Install the new Switch Unit, screws and connectors.
REMOVING THE WOOFER SPEAKER
1. Disconnect connector from Woofer Speaker, remove 5 screws and lift to
detach.
2. Refer to these instructions to remove the opposite Woofer Speaker.
REMOVING THE WLAN MODULE AND HW BOARD
1. Disconnect connector, remove 2 screws and lift to detach the Bracket
Module.
Bracket Module
Bracket Module
2. Release 3 locking clips to detach the Cover Module from Bracket Under,
then remove HW Board.
Bracket
Under
Bracket
Under
Cover
Module
Cover
Module
HW Board
HW Board
3. Release 3 locking clips to detach the WLAN Module.
WLAN
Module
WLAN
Module
