Stereo Headset
Operating Instructions
Manual de instrucciones
4-418-200-
31
(1)
©2011 Sony Corporation
Printed in Thailand
XBA-1VP
Specifications
Headphones
Type:
Closed, Balanced Armature
Driver unit:
Balanced Armature
Power handling capacity:
100 mW (IEC*)
Impedance:
16 Ω at 1 kHz
Sensitivity:
108 dB**
Frequency response:
5 Hz – 25,000 Hz
Cord:
1.2 m (47
1
/
4
in) (Y-type)
Plug:
Four-conductor gold-plated stereo mini plug
Mass:
Approx. 3 g (0.11 oz) (without cord)
Microphone
Design:
In-line microphone
Type:
Electret condenser
Open circuit voltage level:
–38 dB (0 dB = 1 V/Pa)
Effective frequency range:
20 Hz – 20,000 Hz
Supplied accessories
Hybrid silicone rubber earbuds: SS (red) (2), S (orange)
(2), M (green) (attached to the unit at the factory) (2),
L (light blue) (2) / Noise isolation earbuds: S (orange)
(2), M (green) (2), L (light blue) (2) / Cord adjuster
(winds cord up to 50 cm (19
3
/
4
in)) (1) / Clip (1) /
Carrying pouch (1) / Conversion cord (1) / Card
warranty (1)
*
IEC = International Electrotechnical Commission
** 150 mV input
Design and specifications are subject to change without
notice.
iPhone
®
is a trademark of Apple Inc.
Optional replacement earbuds can be ordered from
your nearest authorized Sony retailer or www.sony.
com.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this equipment.
About noise isolation earbuds
Supplied noise isolation earbuds provide a snug fit for
effective attenuation of ambient noise.
Notes
Prolonged use of snugly fitting earbuds may strain
your ears. If you experience discomfort, discontinue
use.
The pressure-relieving urethane cushion is extremely
soft. If it breaks or detaches from the earbuds, it will
not take its correct position and the earbuds will lose
their noise isolation function.
The urethane cushion may deteriorate over time. If
the pressure-relieving power is lost and the urethane
cushion hardens, the earbuds may lose their noise
isolation function.
Do not wash the earbuds. Keep them dry, otherwise
they may deteriorate quickly.
About hybrid silicone rubber earbuds
Keep earbuds clean. To clean the earbuds, wash them
with a mild detergent solution.
Removing the headphones
After use, remove the headphones slowly.
Note
Headphones are designed to fit closely in your ears. If the
headphones are pressed hard while in use or taken off too
quickly, they may cause injury.
Wearing headphones may produce a diaphragm click
sound. This is not a malfunction.
Precautions
High volume may affect your hearing.
For traffic safety, do not use while
driving or cycling.
Install the earbuds firmly. If an earbud
accidentally detaches and is left in
your ear, it may cause injury.
Do not leave the stereo headphones in a location
subject to direct sunlight, heat or moisture.
Compatible products
Use this unit with smartphones.
Notes
If the microphone of the unit does not function, or
you feel the volume level is not enough, connect the
unit to your smartphone via the supplied conversion
cord.
This unit is not guaranteed to operate digital music
players.
Using the Answer/End button
*
Press once to answer the call. Press again to end.
Available operations for iPhone
Plays/pauses a track of the connected iPhone product
with a single press. Skips to the next track with a double
press. Skips to the previous track with a triple press.
Starts the “VoiceOver**” feature with a long press (if
available).
Hold down for about two seconds to reject an incoming
call. When you let go, two low beeps confirm the call
was rejected.
*
The button function may vary depending on the
smartphone.
** Availability of the “VoiceOver” feature depends on
iPhone and its software version.
Features
Earbuds with remote controller for smartphone
Easy-to-use remote control (for smartphone).
Handsfree headset with microphone
Newly developed Balanced Armature driver
unit
Newly developed micro-size driver unit (full-range)
reproduces smooth and clear vocal sound.
Newly developed Double Layered Housing
Liquid Crystal Polymer inner housing and special
ABS outer housing reproduce clear, distortion-free
mid-high range.
Noise-blocking design
Noise-blocking design attenuates ambient noise and
sound leakage.
Super-small body
Balanced Armature driver unit allows for a super
small body, and ultimate wearing comfort.
How to use
Clip
Earbuds
Hybrid silicone rubber earbuds
Noise isolation earbuds
English
Stereo headset
Note on static electricity
Static electricity accumulated in the body may cause
mild tingling in your ears.
To minimise the effect, wear clothes made from natural
materials.
L
M
L
M
S
S
SS
Pressure-relieving
urethane cushion
Microphone
Volume
*
Answer/End
* There is a tactile dot beside
MAX of the volume control.
