Sony VPH-G70Q, Руководство по установке

Страница: 28 / 362

28
(EN) Connections
Connections
R-Y
R
P
R
G
Y
B-Y
B
P B
SYNC
HD
VD
INPUT A S VIDEO
OUT
IN
C IN
Y IN
VIDEO
OUT
IN
ABL LINK
OUT
IN
TRIGGER
IN
PLUG IN
POWER
OUT
REMOTE
INDEX
RS-422A
CONTROL S
IN
OUT
AC IN
MAIN POWER
ON OFF
100~120V 15A 250V
200V~240V T6.3A 250V
MODE
REMOTE1
Using the Signal Interface Switcher
When you connect the PC-1271/1271M Signal Interface Switcher (not
supplied) to the IFB-40 Signal Interface Board (installed on the projector by
default), you can connect easily various input sources.
You can select up to 16 inputs by pressing the SWITCHER/INDEX keys on
the remote control or by setting SWITCHER in the INPUT SELECT menu.
When the switcher is connected to the projector using the SIC-M or CCQ-BRS connecting cable
to
REMOTE 1
OUT
Rear
Video
equipment
AC power cord
(supplied)
to a wall outlet
R G B SYNC/HD VD
to RGB output
to video output
to S Video output
VIDEO IN
Choose the appropriate cable from the following table.
1 m 2 m 5 m 10 m 15 m 25 m 50 m
— CCQ-2BRS CCQ-5BRS CCQ-10BRS — CCQ-25BRS CCQ-50BRS
SIC-M-1 — SIC-M-5 — SIC-M-15 SIC-M-25 SIC-M-50
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz. When projecting the video signal which
exceeds 70 MHz, connect the signal source to the INPUT A connectors using
the 5BNC cables.
Setting up
• Set INPUT-A in the SET SETTING menu to RGB.
For details, see “The SET SETTING Menu” on page 51 (EN).
• Select VIDEO or S VIDEO by pressing the INPUT SELECT keys on the
remote control or by setting VIDEO in the INPUT SELECT menu.
For details, see “The INPUT SELECT Menu” on page 45 (EN).
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
S VIDEO IN
PC-1271/1271M
Switcher
IFB-40 Signal Interface Board
IN
SIC-M or CCQ-BRS
connecting cable
Video
equipment
Computer
AC IN