37
Connecting peripheral devices
Hardware Guide
Connecting to a network
Your computer comes with a built-in Ethernet interface.
To connect to a network, proceed as follows:
1
Connect your 10BASE-T/100BASE-TX Ethernet
cable (not supplied) to the Ethernet port, identified
by the symbol
, on the back of the computer.
If there is a sticker covering the Ethernet port, this
is to remind customers in Germany not to insert an
ISDN cable (see caution below).
2
Go to
Start
, right-click
My Computer
and select
Properties
.
3
Click the
Hardware
tab and select
Device
Manager
.
The
Device Manager
screen appears with the list
of devices.
4
Under
Network Adapters
, right-click the name of the adapter and click
Properties
.
5
Under
Device Usage
, select
Use this device (enable)
.
6
Click
OK
to close the
Properties
window.
The Ethernet connection is now enabled.
!
Connect only 10BASE-T/100BASE-TX cables to the Ethernet port. Using other cables or a telephone cable may cause a malfunction, excessive heat or even fire in the port.
If using this computer in Germany, please make sure you do not use an ISDN cable. It is physically very similar, but its higher voltage of 12V may destroy the motherboard
inside the computer.
Содержание VAIO PCV-D11M
Страница 1: ...N Hardware Guide V G C M 1 s e r i e s P C V D 1 1 M ...
Страница 43: ...42 n N Upgrading your VAIO computer Hardware Guide 4 Set the cover aside ...
Страница 45: ...44 n N Upgrading your VAIO computer Hardware Guide 7 Insert new memory as shown ...
Страница 46: ...45 n N Upgrading your VAIO computer Hardware Guide 8 Put the memory cover back in place ...
