Sony VAIO PCG-Z600HEK, Руководство пользователя

Страница: 63 / 85

Sony Not
e
book Us
er
G
u
id
e
Getting help
63
n N
Confirm that the power cord and all cables are connected firmly.
If you have plugged the computer into a UPS, make sure the UPS is turned on and works.
If you are using an external display, check that it is plugged into a power source and turned on. Check
that you have switched to the external display and that the brightness and contrast controls are adjusted
correctly.
Moisture condensation may have occurred. Do not use the computer for at least one hour and then turn
it on.
When the internal backup battery is low on power, it may not be able to start your system properly.
If the message Press <F1> to resume, <F2> to setup appears at the bottom of the display, you need
to initialize the BIOS.
The message Press <F1> to resume, <F2> to setup appears at startup
If the floppy disk drive is empty, proceed as follows to initialize the BIOS:
1 Remove any peripheral devices connected to the computer.
2 Turn off the computer.
3 Turn on the computer and press <F2> when the Sony logo appears.
The BIOS setup menu screen appears.
4 Press the arrow keys to select the Exit menu.
5 Press the arrow keys to select Get Default Values and then press <Enter> . The message Load default
configuration now? appears.
6 Make sure that [Yes] is selected and then press <Enter>.
7 Press the arrow keys to select Exit (save changes) and then press <Enter> .
The message Save configuration changes and exit now? appears.
8 Make sure that [Yes] is selected, then press <Enter> .
The computer restarts.