Sony UWP-X5, Руководство по эксплуатации

Страница: 19 / 28

19 Operation
Operation
The procedure below is the same for the
UTX-B1 and URX-M1.
1
Make all necessary connections on the
tuner.
For examples of UWP-X5 component
connections, see “System Configuration” on
page 20.
2
Set the transmission channel on the
transmitter, and then turn off the unit.
For details on setting the transmission
channel, see “Setting the transmission channel
(UTX-B1 only)” on page 15.
3
Turn on the tuner.
The parameters that were in the display
section when the tuner was last turned
off appear again.
Before turning on the tuner, turn down
the volume of the equipment
connected to the tuner.
Otherwise, noise will be produced
when the tuner is turned on.
4
Set the reception channel on the tuner.
For details on setting the reception channel,
see “Setting the reception channel (URX-M1
only)” on page 15.
5
Turn on the transmitter.
If noise is heard
Depending on the environment where the
UWP-X5 components are installed,
external noise or radio waves may disrupt
transmission on certain channels.
When selecting a channel under these
circumstances, turn off the transmitter.
Then, on the tuner, select a channel for
which the RF indications do not appear in
the display section or for which the RF
indicator does not light up (i.e., a channel
free from noise or radio wave interference).
Set the same channel on the transmitter.
To prevent interference or noise, please
take the following precautions.
• Do not use two or more transmitters with
the same wireless channels.
• When operating two or more UWP-X5’s
simultaneously, set each package to a
different channel within the same
channel group.
• Keep the reception antenna and the
transmitter separated more than 3 meters
(9 feet 11 inches).
• When operating two or more UWP-X5’s
simultaneously with the same channel
group, make sure that they are at least
100 meters (330 feet) apart, but within
clear sight of each other. (The actual
distance may differ depending on the
circumstances.)
Note
Note