Sony UP-DR100, Инструкция по эксплуатации, Страница: 52 / 112

M
is
c
el
lane
ous
Error and Warning Messages
52
SCSI-2 Interface
Connectors Two 50-pin, half-pitch
Terminator Internal (DIP switch enable/disable)
SCSI ID setting 0 to 7 (DIP switch selectable)
Transfer speed Max. 10 MB/sec (Fast SCSI)
Design and specifications are subject to change without
notice.
Error and Warning
Messages
Error and warning messages appear on the information
display under the following conditions. Please take the
remedial actions shown next to the message to correct
the condition.
Error messages
When a problem occurs, the ALARM indicator on the
front panel lights in red, and an error message appears
on the information display. Please take the remedial
actions shown next to the message to correct the
condition.
Message Description and Remedy
DOOR OPEN The front door is open.
t Close the front panel until it is
locked securely (page 40).
FEED ERROR Paper cannot be fed or ejected
correctly.
t
Load the paper roll correctly.
(page 43)
MECHA TROUBLE • The ink ribbon may break.
t
Repair it with adhesive tape.
(page 41)
• The paper corresponding to the
designated number of sheets is
exhausted.
t Load a new ink ribbon and paper
roll. (page 37)
• The ink ribbon corresponding to the
designated number of sheets is
exhausted.
t Load a new ink ribbon and paper
roll. (page 37)
• Mechanical trouble has occurred in
the printer.
t The ink ribbon and paper roll are
not loaded correctly. Load them
correctly. (page 37)
t If the message does not
disappear even after performing
the above remedy. Contact your
supplier or nearest Sony Service
Center.
MEDIA MISMATCH An incompatible ink ribbon and paper
are loaded.
t
Load the compatible ink ribbon and
paper roll taken from the same
package. (page 51)
NO PAPER The paper roll is not loaded.
t Load paper roll.(page 37)
NO RIBBON The ink ribbon is not loaded.
t
Load an ink ribbon.(page 37)