14
Be careful not to have any spots of high illumination in the
rectangle.
3
Adjust the lens iris opening.
With a manually adjusted lens:
Set the opening to an
appropriate value.
With a lens which has automatic iris control:
Set the
lens’ automatic/manual iris control switch to
automatic.
4
Use the MSU and RCP to run the Auto White Balance
(AWB).
White balance automatic adjustment begins.
During adjustment, the message “AWB : EXECUTING”
will be displayed on the viewfinder screen.
A message like the one in the figure below will be
displayed, and the adjustment process will complete. The
adjusted value is automatically stored.
When using a zoom lens with automatic iris control capability,
hunting
1)
may occur. Adjust the lens’ iris gain control (labeled
IG, IS, S, etc.).
1) Hunting: The automatic iris responds over and over, and the image
repeatedly darkens and lightens.
For more information, refer to the lens’ operation manual.
When automatic white balance adjustment fails
If the white balance adjustment process does not end
successfully, the error message “AWB : NG” will be displayed
on the viewfinder screen for approximately three seconds.
If this error message is displayed, try white balance
adjustment again.
If the error message continues to be displayed after several
attempts, the camera requires internal inspection.
Setting the Electronic Shutter
This section explains the different modes which can be used
for the electronic shutter and gives the procedures for setting
the shutter mode and shutter speed.
About the shutter modes
The shutter modes that can be used with the electronic shutter
of the camera and the shutter speeds that may be selected are
as follows:
*
The values in the table are those with 59.94P. With other formats,
the available values are different.
*
When shooting at double speed, the actual exposure time will be
half of the displayed value and the actual frequency will be double
the displayed value.
Selecting the shutter mode and speed
Use MSU and RCP to change the shutter speed.
The current shutter setting will be displayed on the viewfinder
screen for about three seconds.
Example: “SHUTTER: 1/250”
Example: 59.94P
Setting the Focus Assist Functions
Using the OPERATION menu, the assist functions for easier
focusing on the viewfinder, can be activated.
Adding the VF detail signal
Adding the VF detail signal to sharp edges in the image on the
viewfinder screen makes it easier to check the focusing
condition by observing changes in the detail signal or in the
color converted from the detail signal (color detail).
The focus setting where the detail signal becomes strongest is
the best focus setting.
1
Turn on the camera.
2
Set the DISPLAY switch to MENU while holding the
MENU SEL knob/ENTER button pressed.
The camera enters Menu mode, and “TOP” is displayed at
the upper right corner of the screen.
3
Turn the MENU SEL knob/ENTER button to align the
arrow marker (
,
) to TOP and press the MENU SEL
knob/ENTER button.
The TOP MENU screen appears.
Note
Note
A rectangle centered in the screen.
The length of the sides must be at least 70% of
the height and width of the screen.
Within this rectangle, there must be an area of
white greater than 10% of the entire screen.
AWB:OK
Shutter modes and speeds
Shutter mode
Shutter speeds
*
Usage
Standard
1/100, 1/125, 1/250,
1/500, 1/1000, 1/2000
(seconds)
Use to obtain clear images
of quickly moving subjects
ECS
(Extended
Clear Scan)
Continuously variable
in the range of
59.96 Hz to 4600 Hz
Use to obtain images on
video monitors without
horizontal striping
1/100
1/2000
1/1000
1/500
1/250
1/125
Standard mode
ECS mode
<TOP MENU>
USER
USER MENU CUSTOMIZE
ALL
OPERATION
PAINT
MAINTENANCE
FILE
DIAGNOSIS
