Sony STR DA5500ES - AV Network Receiver, Руководство по эксплуатации

Страница: 124 / 198

124 GB
5
Prepare the recording
component.
Insert a blank video tape, etc., into the
recording component (VIDEO 1) for
recording.
6
Start recording on the
recording component, then
start playback on the playback
component.
Notes
• Some sources contain copy guards to prevent
recording. In this case, you may not be able to
record from the sources.
• The audio input signals from the MULTI
CHANNEL INPUT jacks are not output.
• Only analog input signals are output from the
analog output jack (for recording).
• Only digital input signals are output from the
digital output jack (for recording).
• HDMI sound cannot be recorded.
Switching the command
mode of the receiver and
the remote
You can switch the command mode
(COMMAND MODE AV 1 or COMMAND
MODE AV 2) of the receiver and the remote.
Switch the command mode from the initial
setting to the appropriate setting, if other Sony
component is operated accidentally by the
same remote, when you are operating the
receiver using the remote supplied with the
receiver.
The command modes of both the receiver and
the remote are those of the initial setting
(COMMAND MODE AV 2).
The receiver and the remote, on the contrary,
should use the same command mode. If the
command modes of the receiver and the
remote are different, you cannot use the
remote to operate the receiver.
Turn on the receiver while pressing
2CH/A.DIRECT.
When the command mode is set to “AV2,”
“COMMAND MODE [AV2]” appears on the
display.
When the command mode is set to “AV1,”
“COMMAND MODE [AV1]” appears on the
display.
Switching the command mode of
the receiver
2CH/A.DIRECT